We have DataPage+2012 and it is saving location OK but not profile. It was saving both until I added some coding to print to report if using over 75% of tolerance, then it quit saving profile data. Below is a sample of a profile callout (not saving) and a location callout (saving). Any Ideas? Thanks in advance.
DIM XX_LF_PROFILE= PROFILE OF SURFACE OF PLANE XX_LF FORMONLY LEAST_SQR UNITS=MM ,$
GRAPH=OFF TEXT=OFF MULT=1.00 ARROWDENSITY=100 OUTPUT=BOTH
AX MEAS NOMINAL +TOL -TOL DEV OUTTOL
M 0.003 0.000 0.100 0.000 0.003 0.000 #--------
ASSIGN/V3=(ABS(XX_LF_PROFILE.DEV)/XX_LF_PROFILE.PTOL)*100
ASSIGN/V4=V3 + "% >>>>>"
IF/V3>=75
COMMENT/REPT,
~~1*************************************************************************
COMMENT/REPT,
"<<<<< XX LF PROFILE USING OVER 75% OF TOLERANCE! CHECKS: " + V4
COMMENT/REPT,
~~1*************************************************************************
END_IF/
DIM XX_LF_LOCATION= LOCATION OF PLANE XX_LF UNITS=MM ,$
GRAPH=OFF TEXT=OFF MULT=1.00 OUTPUT=BOTH HALF ANGLE=NO
AX MEAS NOMINAL +TOL -TOL DEV OUTTOL
X -45.723 -45.700 0.200 0.200 -0.023 0.000 ---#-----
END OF DIMENSION XX_LF_LOCATION
ASSIGN/V5=(ABS(XX_LF_LOCATION.X.DEV)/XX_LF_LOCATION.X.PTOL)*100
ASSIGN/V6=V5 + "% >>>>>"
IF/V5>=75
COMMENT/REPT,
~~1*************************************************************************
COMMENT/REPT,
"<<<<< XX LF LOCATION USING OVER 75% OF TOLERANCE! CHECKS: " + V6
COMMENT/REPT,
~~1*************************************************************************
END_IF/
