Does anyone know what is the file name that dumps XSTATS11.tmp in to Data Page?
Right now it saves the data in XSTATS11.tmp, but it doesn't update data page, I have to do it manualy by using Data Editor.
PC DMIS 3.5 MR2
Thanks,
Zoran
I loaded your program in V35MR2. I execute the part program. I am prompted to "OK to Save Statistics?" along with the current Stats Count. I press Yes. At the end of execute I am prompted "Update the Database Now?". Again I press Yes. The data would be sent if I was pointing to a valid DB.
1) Are you getting the initial "OK to Save Stats" message? I ask this because your Stats Count is sitting at 1. It shoud increment each time stats are saved.
2) Are you getting the "Update the database now" message"
3) You really should have "READ=10,WRITE=20,MEMPAGES=64" instead of 0 for the values but I do not think that matters in this case.
4) DIM LOC1 does not have a feature being dimensioned. I put in TRIM24.
5) How are you executing? Complete execute from the beginning or a partial?
I loaded your program in V35MR2. I execute the part program. I am prompted to "OK to Save Statistics?" along with the current Stats Count. I press Yes. At the end of execute I am prompted "Update the Database Now?". Again I press Yes. The data would be sent if I was pointing to a valid DB.
1) Are you getting the initial "OK to Save Stats" message? I ask this because your Stats Count is sitting at 1. It shoud increment each time stats are saved.
2) Are you getting the "Update the database now" message"
3) You really should have "READ=10,WRITE=20,MEMPAGES=64" instead of 0 for the values but I do not think that matters in this case.
4) DIM LOC1 does not have a feature being dimensioned. I put in TRIM24.
5) How are you executing? Complete execute from the beginning or a partial?
