How can I handle the following position in Q-DAS. With the bonus the feature passes. However, in Q-DAS this will be flagged as a Fail since it does not consider bonus. Is there a way to always deduct bonus from the measured value?
It is HIGHLY ADVISABLE that you get out of the habit of using spaces or special characters in your naming conventions (feature names, alignment names, dimension names, etc). You should only be using Letters, numbers, or UNDERSCORE. Using your pic above I would instruct my CMM people to name that dimension something along the lines of "NUM_16_0PNT430_at_S3_B3"
PC DMIS will let you violate the above "rule". However..this will mess with you when you try to do upper level stuff involving math, looping, etc.
Good-luck hope you get your original question answered
It is HIGHLY ADVISABLE that you get out of the habit of using spaces or special characters in your naming conventions (feature names, alignment names, dimension names, etc). You should only be using Letters, numbers, or UNDERSCORE. Using your pic above I would instruct my CMM people to name that dimension something along the lines of "NUM_16_0PNT430_at_S3_B3"
PC DMIS will let you violate the above "rule". However..this will mess with you when you try to do upper level stuff involving math, looping, etc.
Good-luck hope you get your original question answered
