error at transmitter signal

Leitz PMM866

When moving in y-axis, it halts abruptly and this message appears:
"Error at Transmmitter Signal Y-Axis"

Tried shutting down completely and re-booting, but to no avail. Machin still faults out, but not always in the same location.

Any suggestions?????
Circuit Board?
Cable connector?
Bad Karma?

Thanks in advance!

Parents

dph51 over 13 years ago

The room temp was too high, (bean counters wanted to save money, so A/C was turned off room temp 77°) so we got the A/C running at the right temp. Let the CMM sit for a dy to normalize, and it seems to work ok. (For now at least).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

dph51 over 13 years ago

The room temp was too high, (bean counters wanted to save money, so A/C was turned off room temp 77°) so we got the A/C running at the right temp. Let the CMM sit for a dy to normalize, and it seems to work ok. (For now at least).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data