Quindos Contour measurement of a roll

Hello, everyone

How can I reliably measure and plot the contour of the roll with the Quindos 7 basic package?
A star button is available

Perhaps someone has a similar example or an idea how to program it most professionally ???
We have a lot of these roles that have different sizes, so it should be programmed with variables as best as possible.
It would also be cool to visualize the results via a plot.

Thanks for the support
Best regards

Parents

Karin Schneider over 3 years ago

Hello. The key is the 34mm torus. I guess the best solution is METOR.

The uncertainty comes when you try to evaluate the 34mm diameter as you only have 120degrees of arc.

Non-the-less I would give it a try, the tolerances are not that tight.

Just my thoughts.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Hribe85 over 3 years ago in reply to Karin Schneider

OK that's a good approach.
But how can I generate the points for the METOR command in automatic mode???
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Hribe85 over 3 years ago in reply to Karin Schneider

OK that's a good approach.
But how can I generate the points for the METOR command in automatic mode???
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data