Measuring Pinion and Crown wheel

Hi Anders,

First off, the parameters are probably wrong, hence the machine moves off the part. 

Create the QUE before using CadCreateSpribv with SPIRBV_CADPTS. Activate the correct CSY beforehand and use the correct parameter set.

Have fun!

Thanks for your response.

I suspect that too, but which parameter(s) should I change?
I tried lowering the speed and acceleration but it didn't help.
I have tried both Leitz scanning and scanning of a known contour.
It should be mentioned that I measure with the round table activated.
So far I have only tried to scan on pinions.

OK. The machine parameters are probably not the problem.

Have you shifted the coordinate system to the cone tip or used this input : 

I shifted the coordinate system. Point measurement works fine. 

OK. Please send the program & gear drawing/parameters to hotline.quindos@hexagon.com.

Ok

Will try to get another detail to share.

I'm not allowed to share the ones I've measured so far, they're prototypes.

It may take some time before I can measure pinions again.

Hello Timothy.
I have sent the program, drawing and gear data to the hotline address.