has onyone personalized a tractor semitrailer assembly model in Adams/car to carry out a particular simulation?

Hi,

I modified the dafault assembly of tractor semitrailer in Adams/car Truck shared database to perform an analysis. In particular I created two new templates and related subsystems and adding them to the assembly. In spite of previuos runs, where I defined two temlates with same "major rules", this time the assembly compiler doesn't show any error about missing or incorrect input/output communicators. So I don't really have idea why the simulation doesn't work. I tried a straight-line maintain with "quasi-static straight-line setup" flagged and unflagged, but the error is still appearing.

Does anyone have any ideas?

Thank you all

Parents

0 Jesper Slattengren over 6 years ago

After you run your simulation and it fails, use the event builder to open the event xml file. In there you change your static to "none" and then press "Save and Run". See if this works better. It often hangs on static due to wrong preload in your airbags or springs. With this method, you usually get at least a few dynamic timesteps out and that will help you debug your model.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Jesper Slattengren over 6 years ago

After you run your simulation and it fails, use the event builder to open the event xml file. In there you change your static to "none" and then press "Save and Run". See if this works better. It often hangs on static due to wrong preload in your airbags or springs. With this method, you usually get at least a few dynamic timesteps out and that will help you debug your model.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data