I've been following the ADM743 FSAE tutorial and while completing WORKSHOP2/Part2 (Simulating a Full Vehicle Assembly). I get an error in the message window stating the model isn’t defined? So where and when do I need to define the model?

Parents

0 Alexis Del Rio over 5 years ago
Hi,

It seems to me that the model you are loading is not the one in the tutorial:

The correct tutorial model should look like similar to the one below:

When I load the tutorial model I get this:

Your model cannot be simulated because as soon as Adams tries to load the tires it fails as shown in the log file you attached. So:

Check you are loading the tutorial model and not your prototype vehicle.

Check your model loads correctly as per the tutorial example, if it doesn't investigate.

If you don't understand the issue compare your database with that of someone else.

Thanks,
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Alexis Del Rio over 5 years ago
Hi,

It seems to me that the model you are loading is not the one in the tutorial:

The correct tutorial model should look like similar to the one below:

When I load the tutorial model I get this:

Your model cannot be simulated because as soon as Adams tries to load the tires it fails as shown in the log file you attached. So:

Check you are loading the tutorial model and not your prototype vehicle.

Check your model loads correctly as per the tutorial example, if it doesn't investigate.

If you don't understand the issue compare your database with that of someone else.

Thanks,
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data