I've been following the ADM743 FSAE tutorial and while completing WORKSHOP2/Part2 (Simulating a Full Vehicle Assembly). I get an error in the message window stating the model isn’t defined? So where and when do I need to define the model?
I've been following the ADM743 FSAE tutorial and while completing WORKSHOP2/Part2 (Simulating a Full Vehicle Assembly). I get an error in the message window stating the model isn’t defined? So where and when do I need to define the model?
I've downloaded the 2012 and 2018 fsae databases. I'll run through the tutorial again and hopefully get them to load successfully. I'll report back either way.
I've downloaded the 2012 and 2018 fsae databases. I'll run through the tutorial again and hopefully get them to load successfully. I'll report back either way.
