How to create a Revolution in A/Car template...

I have x,y,z coordinates of a profile I'd like to make into a revolution in an A/Car template. In A/View I would just make a dummy revolution by picking points and then replace the points in the mod dbox. This seems (embarrassingly) like it's way to hard in Car so far. How are people doing this?

Parents

0 greg.wheeler over 5 years ago
Hi Jim. There's no native support for revolutions in Car's template builder.

I see a couple alternatives:

Switch to View mode and build it as you described.

Use the Command Navigator to create the revolution with a profile curve. You can create the curve as an "outline" which is parameterized to construction frames and/or hardpoints.

Use the Command Navigator to create the revolution with "points for profile," where you supply a list of x,y,z coordinates.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 greg.wheeler over 5 years ago
Hi Jim. There's no native support for revolutions in Car's template builder.

I see a couple alternatives:

Switch to View mode and build it as you described.

Use the Command Navigator to create the revolution with a profile curve. You can create the curve as an "outline" which is parameterized to construction frames and/or hardpoints.

Use the Command Navigator to create the revolution with "points for profile," where you supply a list of x,y,z coordinates.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data