Static equilibrium analysis problem.

Question

I am trying an H-arm Camber link suspension type, but I get an error like this "Static equilibrium analysis has not been successful". I checked the constraints with other templates but I couldn't find mistake I had done. Can someone please help me to sort it out this problem.

Attached Files (4)

Rear_subsystem.sub.zip

trail_1_parallel_travel.msg

_H_arm_suspension.tpl.zip

Rear.asy.zip

Jesper Slattengren · Accepted Answer

The wacky thing was that your top mount joint was active only in kinematic mode so it was deactivated by default.

To summarize:

Create a joint between lower strut at H-arm. Spherical is ok if you change the cylindrical joint between lower and upper strut to a translational. 
 Change the hooke joint at the top of the strut to be always active.