Adams & Simulink Executing out of Order

Adams non-linear plants are simulating during the simulink compilation phase. All ADAMs inputs are always zero. This error is occurring on Windows 10 with Adams 2017 and Adams 2015 on Matlab 2017a and Matlab 2015b. All combinations are tested and reproduce the same error.

Old simulations from Adams 2015.1, compiled in Windows 7 with Matlab 2012b still run correctly.

Parents

0 Jesper Slattengren over 7 years ago

We are running several different versions of ADAMS and Matlab and have not seen this problem. Of course we are using the proper Matlab version. The ADAMS versions we have been using in the last six months are 2012, 2015.1.1 and 2017.

A note: If you use Simulink Coder and create a dll and import that to ADAMS, it is much less picky on versions. The same dll has worked with several different ADAMS versions.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Jesper Slattengren over 7 years ago

We are running several different versions of ADAMS and Matlab and have not seen this problem. Of course we are using the proper Matlab version. The ADAMS versions we have been using in the last six months are 2012, 2015.1.1 and 2017.

A note: If you use Simulink Coder and create a dll and import that to ADAMS, it is much less picky on versions. The same dll has worked with several different ADAMS versions.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data