Moments and Forces output of Flexible bodies is zero?

Hi, Everyone.

I met a problem of outputting responses of a flexible body.

I just use a cantilever beam as a flexible body in ADAMS, and applying a moment load at one side, the 'total force on point' and 'total torque on point' output of mass center marker are all Zero. I checked the displacement is correct, but have no idea about the forces and moments.

Does anybody know the problem, I am a beginner of ADAMS and would be really appreciated for your kind help. Thank you very much!

Shuai

Parents

0 shuai.wang over 7 years ago

Actually, I have measurement strain data of a Wind turbine drivetrain shaft at specific points. I want to compare the Adams simulation with the measurement. Cantilever model is a test.

I heard that Admas can report the strain and stress on a flexible body, maybe I can use them instead of using moments.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 shuai.wang over 7 years ago

Actually, I have measurement strain data of a Wind turbine drivetrain shaft at specific points. I want to compare the Adams simulation with the measurement. Cantilever model is a test.

I heard that Admas can report the strain and stress on a flexible body, maybe I can use them instead of using moments.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data