How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?
How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?
Thanks for the input example. Helped very much. I now have a bushing that deactivates based upon its reactive force.
A problem I have now, is the bushing deactivates about 0.0021 seconds later than it should. I’ve made several iterative runs changing the sensor characteristics with no success.
Thanks for the input example. Helped very much. I now have a bushing that deactivates based upon its reactive force.
A problem I have now, is the bushing deactivates about 0.0021 seconds later than it should. I’ve made several iterative runs changing the sensor characteristics with no success.
