Adams

Adams General Forum How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?

Adams requires membership for participation - click to join

State Not Answered
Replies 5 replies
Subscribers 11 subscribers
Views 78 views
Users 0 members are here

Options

Related

How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?

mike.goettel over 7 years ago

How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?

Parents

0 greg.wheeler over 7 years ago

To get super precise you may need to change your model units to milliseconds instead of seconds.

Also, in the sensor setup, did you select "Generate additional output step at event"? And of course you can change the error tolerance of the sensor.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 greg.wheeler over 7 years ago

To get super precise you may need to change your model units to milliseconds instead of seconds.

Also, in the sensor setup, did you select "Generate additional output step at event"? And of course you can change the error tolerance of the sensor.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data