How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?
How do I conditionally deactivate a bushing during a solution run. I want to deactivate the bushing when the internal force on that bushing reaches a maximum?
Hello, in attachment you have cmd with simple model. Model consists of one part, loaded by increasing force, attached by two bushings, there is one sensor which stops simulation, when force in left bushing reaches prescribed value.
Hello, in attachment you have cmd with simple model. Model consists of one part, loaded by increasing force, attached by two bushings, there is one sensor which stops simulation, when force in left bushing reaches prescribed value.
