Error in doing flex of lower control arm using Viewflex in Aview, failed in mnf creation

Now I have succeded with the Boolean function and able to combine the bodies.Next I want to flex the lca using Viewflex,I am getting this error mnf creation failed

I have used this as an input

Can anyone solve this

Parents

0 Maziar R over 6 years ago

Sundeep,

You would need to go to the Advanced Settings to (a) properly generate a mesh and (b) select proper attachment points. When generating the attachment points, you would need to carefully create RBE2 elements to connect the attachment marker (master node) to the slave nodes on surfaces, edges, or similar.

If you need help with this and have access to our eLearning courses, I recommend that you go through the course ADM710 . For more details on ViewFlex, you can review section 11.

I hope this helps.

Thanks,

Maziar
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Maziar R over 6 years ago

Sundeep,

You would need to go to the Advanced Settings to (a) properly generate a mesh and (b) select proper attachment points. When generating the attachment points, you would need to carefully create RBE2 elements to connect the attachment marker (master node) to the slave nodes on surfaces, edges, or similar.

If you need help with this and have access to our eLearning courses, I recommend that you go through the course ADM710 . For more details on ViewFlex, you can review section 11.

I hope this helps.

Thanks,

Maziar
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data