Error in doing flex of lower control arm using Viewflex in Aview, failed in mnf creation

Now I have succeded with the Boolean function and able to combine the bodies.Next I want to flex the lca using Viewflex,I am getting this error mnf creation failed

I have used this as an input

Can anyone solve this

Parents

0 Sudeep Tyagi over 6 years ago

Hey Maziar,I am now able to create mnf file successfully using Viewflex after doing proper attachments.I called that mnf file in Adams car to flex the lower control arm .Now I want to export loads for FEA after doing dynamic suspension analysis ,Its showing deformation but non von mise stresses during animation.

I am not able to get the von mises stress distribution in my countor plot but able to get deformation plots

Pls answer this and ask your coullegue to contact me as I need support through mail.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Sudeep Tyagi over 6 years ago

Hey Maziar,I am now able to create mnf file successfully using Viewflex after doing proper attachments.I called that mnf file in Adams car to flex the lower control arm .Now I want to export loads for FEA after doing dynamic suspension analysis ,Its showing deformation but non von mise stresses during animation.

I am not able to get the von mises stress distribution in my countor plot but able to get deformation plots

Pls answer this and ask your coullegue to contact me as I need support through mail.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data