hexagon logo

Is there any easier way of making tire blow out simulation?

Hi,
I am trying to run a tire blow out simulation. I made some research and it seems the easiest way to use Ftire with inflation pressure around 0 bars.
I got an ftire data with pressures with the tire tests were performed at 8.5 and 10 bars.
I would like to get your opinions about making the analyses with the extrapolation form 8.5 to 10 bars to 0 bars inflation pressures would be realistic or not.
During my research I couldn't find any study with Adams in tire blow out analyses, have you seen any study on tire blow out analyses in Adams? Is there any easier way?
Regards,
Yahya,​
Parents
  • Just to add some more information:
    • I tried to add the block you proposed to the demo Ftire (205/55R16) from the acar_shared. As expected it had no effect
    • BTW: The latest FTire 2019-1 was used and there was no use_updates_prior_to set that would prevent it from using the latest enhancements.
    • After switching on all the existing activate_xxx_model parameters it still didn't show any signs of loosing pressure at the given time.
    • Unfortunately when trying to RTFM, I found there actually is no manual on the designated site www.cosin.eu/.../ (Seems someone took the old version off and did not upload the latest one ....)
Reply
  • Just to add some more information:
    • I tried to add the block you proposed to the demo Ftire (205/55R16) from the acar_shared. As expected it had no effect
    • BTW: The latest FTire 2019-1 was used and there was no use_updates_prior_to set that would prevent it from using the latest enhancements.
    • After switching on all the existing activate_xxx_model parameters it still didn't show any signs of loosing pressure at the given time.
    • Unfortunately when trying to RTFM, I found there actually is no manual on the designated site www.cosin.eu/.../ (Seems someone took the old version off and did not upload the latest one ....)
Children
No Data