Tyre TIR file customization

I want to add one tyre in the quarter car model in ADAMS View. I want only lateral and longitudinal stiffness in the tyre of radius 275 mm. My objective is to give only base excitation on the tyre print and analyze the tire's angular and translational motion.

I was trying to make the TIR file by editing the available "F tyre.TIR" files in the ADAMS car database.

Kindly guide or provide me the customized 'TIR file' of F-tyre.

Attached Files (1)

0 Micha over 4 years ago

I am not sure if I understand your request. FTire is a fully physical tire model, and always runs 'as a whole'. Like the real tire. It is not possible to only have 'lateral and longitudinal stiffness' without the rest. Please spend 15 minutes or so and read the documentation here: www.cosin.eu/support/documentation/
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Jesper Slattengren over 4 years ago

And you need a separate license to run FTire. As Prof. Gipser says, read up on tire models, not only FTire before you decide what to do.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel