Does Adams View follow the specific rule to calculate the cm marker orientation?

I have a Damper, I used ORI_IN_PLANE to parameterize the orientation of the piston and cylinder. When I apply the function I get exactly the same orientation (design variable still is the same-standard value). However cm-marker orientation is changed! Does anybody know why? how can I control that without parameterizing the cm marker. I want AView to automatically calculate the cm-marker coordinates.

Parents

0 fatemehh over 4 years ago

@Henrik Skovbjerg When I do the simulation after and before applying the function, the results are not the same. The cm marker changes before running the simulation ( DESIGN TIME-right after applying the function), that is why the results change. My objective is to avoid the variation of the cm marker to keep the results the same when the geometry and orientation are the same. Why does the cm marker change when the function is making exactly the same orientation?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 fatemehh over 4 years ago

@Henrik Skovbjerg When I do the simulation after and before applying the function, the results are not the same. The cm marker changes before running the simulation ( DESIGN TIME-right after applying the function), that is why the results change. My objective is to avoid the variation of the cm marker to keep the results the same when the geometry and orientation are the same. Why does the cm marker change when the function is making exactly the same orientation?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data