Retrieve existing scripted simulation as initial condition for different vibration simulations

I am performing scripted simulation prior to Vibration analysis to achieve specific operating point.

Since scripted simulation takes significant amount of time, I would like to reuse existing simulated position for performing further multiple vibration analysis (where input and output channels are changing as well).

Could you please let me know if there is a way to retrieve existing scripted simulation for different vibration simulations?

0 ilapakurti Venkata Naga over 2 years ago

Can you not just design / save the operating Point as a new position/ variant of the model itself?

It will reduce the hassle of first retrieving the position from the previous run.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 harish.sonawane over 2 years ago

No. That is not possible since I am applying initial torque to the model, which deforms different bushings and parts. I want this LOADED POSITION about which the complete model should be linearized during vibration analysis
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Martin Kieltsch over 2 years ago

How about using an acf with SAVE / RELOAD commands ?

Check the solver help on what that does.

In a nutshell: SAVE saves your model and RELOAD "resets" the model to the states saved by SAVE.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel