BCs for flexbodies

Hello,

Is there a way to include SPCs in your model when creating and MNF file for a flexbody? I am asking because when I tried creating an mnf file for a table-like structure, the 1st mode was completely off than when running a simple sol103. The points which were supposed to be constrained were moving freely in the modes (even though I had also included them in ASETS).

Is there another way that I can ensure the validity of the constraints when creating an mnf file?

Thanks,

Josef

Parents

0 Josef K. over 2 years ago

Thanks! This was very helpful. One final question

"(if you didnt lock the respective dofs during the mnf file generation (and I suppose you didnt))"

how do I do this? I mean how do I lock the dofs in Adams/Vieflex?

Thanks,

Josef
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Josef K. over 2 years ago

Thanks! This was very helpful. One final question

"(if you didnt lock the respective dofs during the mnf file generation (and I suppose you didnt))"

how do I do this? I mean how do I lock the dofs in Adams/Vieflex?

Thanks,

Josef
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data