Bearing AT errors

Hello,

I have created a bearing file using Bearing AT in Adams. The bpf (and all related files) were successfully produced, but whenever I try to load the bearing in Adams, it crashes. Is there any chance that my bearing is faulty even though its was succesfully created? Any othe reasons why Adams may crash like this?

Thanks,

Josef

Parents

0 Josef K. over 3 years ago

Right, thanks! This seems to work.

I kind of wanted to use the gears/machinery in the same model though, which by unpluging the machinery is rendered impossible. Would using the Gears AT module solve this? Does Gears AT and Bearings AT work together?

Thanks again,

Josef
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Josef K. over 3 years ago

Right, thanks! This seems to work.

I kind of wanted to use the gears/machinery in the same model though, which by unpluging the machinery is rendered impossible. Would using the Gears AT module solve this? Does Gears AT and Bearings AT work together?

Thanks again,

Josef
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data