How to incorporate flexible body and bearing in MSC Adams Modeler.

Hi everyone.

I have a model like the picture below . The shaft is made flexible, i want to put 2 bearings to support the shaft. How can i define the contact between them in MSC ADams View or Adams Modeler.

And is it possible to create bearings in MSC ADams Modeler?

Besides, when i create the model in ADam Modeler with flexible body, then i change the enviroment to Adams View to build bearing , it seems impossible to run that mode by Run an interactive Simulation command. But i have to change the enviroment to use bearings.

Thanks

Giang

Parents

0 Alexis Del Rio over 3 years ago

Do you need to have actual bearings with contacts? or can you live with a couple of nodes in your flex body and a couple of bushes attached to each node?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Alexis Del Rio over 3 years ago

Do you need to have actual bearings with contacts? or can you live with a couple of nodes in your flex body and a couple of bushes attached to each node?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data