Adams

Adams General Forum End a Simulation with a Sensor and Then Publish the End Time to a Variable.

Adams requires membership for participation - click to join

State Not Answered
Replies 5 replies
Subscribers 11 subscribers
Views 182 views
Users 0 members are here

Options

Related

End a Simulation with a Sensor and Then Publish the End Time to a Variable.

jsph_inc 9 months ago

Hi All,

I have a simulation that I end using a sensor. Thus the simulation end time is determined by when the sensor gets triggered.

Is there a way to send the end time of this simulation to a state or design variable?

Or is there a variable in ADAMS which reports the end time of the simulation (not CPU time).

I tried using the "Event Evaluation" feature in the sensor definition but no luck so far.

thanks,

joe.

Parents

0 Henrik.Skovbjerg 9 months ago

Getting stuff out of the solver - you get a value for each time step. Hence, everything you do will give you an array of values. The TIME signal in the postprocessor shows you the end time when you look at the last value. Same for a state variable containing the function "TIME".

The SENVAL is probably your best option.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Henrik.Skovbjerg 9 months ago

Getting stuff out of the solver - you get a value for each time step. Hence, everything you do will give you an array of values. The TIME signal in the postprocessor shows you the end time when you look at the last value. Same for a state variable containing the function "TIME".

The SENVAL is probably your best option.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data