How to use the keyword "post increment" in .cnt file to change the result write frequency？

I try to change the result output frequency by using .cnt file during simulation. but it doesnot work.

I checked the.out file and found it said"change the post tape frequency:…". It seems that the CNT file does not work. How to use this keyword？

In volc it says 1-5rd as 1st input and 6-10rd as 2st input for 2nd datablock. of "post increment"，it should be 1-10rd as 1st input and 11-20rd as 2nd input

Parents

0 Kiranraj Shetty over 5 years ago

Yes. It works. I tested a sample attached here. You can see in the message in out file

reading option : POST INCRE

       from file : E:\Rigid_Body_Contact_SD_Nonlinear\tip_load_job1.cnt

       write post tape every    200 increments.

As expected, initially the output is written for every increment, and after placing the cnt file from inc # 765 onwards it writes output for 200 increments.

Attached Files (1)

cnt_file_test.zip
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Kiranraj Shetty over 5 years ago

Yes. It works. I tested a sample attached here. You can see in the message in out file

reading option : POST INCRE

       from file : E:\Rigid_Body_Contact_SD_Nonlinear\tip_load_job1.cnt

       write post tape every    200 increments.

As expected, initially the output is written for every increment, and after placing the cnt file from inc # 765 onwards it writes output for 200 increments.

Attached Files (1)

cnt_file_test.zip
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data