I did a simple gravity load analysis in my model to see the stresses and maximum stress distribution only show from where i glued areas. Why results show like that.
I did a simple gravity load analysis in my model to see the stresses and maximum stress distribution only show from where i glued areas. Why results show like that.
The high local stress could be due to contact tying MPCs. You can switch to segment to segment which should give a better stress distribution. You can also use stress-free initial contact under contact interaction.
The high local stress could be due to contact tying MPCs. You can switch to segment to segment which should give a better stress distribution. You can also use stress-free initial contact under contact interaction.
