I applied a glue contact between two meshes and it said 'successfully found a pair' However the glue ptach has a red cross and the glue has an exclamation mark in the tree.
They are under one large assembly, but even when I moved the surfaces and mesh to be in the same part, it didn't fix the error. I think it may be due to the geometry, as it is a complex fabrication, but I'm not sure.
They are under one large assembly, but even when I moved the surfaces and mesh to be in the same part, it didn't fix the error. I think it may be due to the geometry, as it is a complex fabrication, but I'm not sure.
