I have successfully imported an .igs file, which contains a 2D section of a motor. Is it possible somehow to mesh the geometry in 2D? Which file type do you use for 2D geometries?
No apology needed! You should be able to split the cyan surface with the edges of the red surface. When you say it's only picking faces, do you mean you're getting this?
If so, the surface is already split and all you need to do is delete the two overlapping faces on the inside. Does that work for you?
No apology needed! You should be able to split the cyan surface with the edges of the red surface. When you say it's only picking faces, do you mean you're getting this?
If so, the surface is already split and all you need to do is delete the two overlapping faces on the inside. Does that work for you?
