I am looking at exporting an Apex model as a .bdf so that it can be interrogated in Patran. The model session units are mm-kg-s-N
When i look at the export options from the .bdf option i get a number of options for the unit system but none that match the models session units.
The option that i can see are -
m-kg-s-N
cm-kg-s-cN
cm-kg-ms-10^4N
cm-kg-micros-10^10N
mm-kg-ms-kN
cm-g-s-dyn
cm-g-micros-10^7N
mm-g-s-microN
mm-g-ms-N
mm-t-s-N
in-slinch-s-lbf
ft-slug-s-lbf
mm-khyl-s-kgf
mm-kg-s-mN
cm-g-ms-daN
ft-lb-s-lbf
Also it says, if you chose the "Custom" units system, you must ensure that the unit system you have defined is consistent. However, no "Custom" button is present in the down selected box. Where is this "Custom" option?
I am looking at exporting an Apex model as a .bdf so that it can be interrogated in Patran. The model session units are mm-kg-s-N
When i look at the export options from the .bdf option i get a number of options for the unit system but none that match the models session units.
The option that i can see are -
m-kg-s-N
cm-kg-s-cN
cm-kg-ms-10^4N
cm-kg-micros-10^10N
mm-kg-ms-kN
cm-g-s-dyn
cm-g-micros-10^7N
mm-g-s-microN
mm-g-ms-N
mm-t-s-N
in-slinch-s-lbf
ft-slug-s-lbf
mm-khyl-s-kgf
mm-kg-s-mN
cm-g-ms-daN
ft-lb-s-lbf
Also it says, if you chose the "Custom" units system, you must ensure that the unit system you have defined is consistent. However, no "Custom" button is present in the down selected box. Where is this "Custom" option?
