I am trying to model lateral float into a joint using RBE2-to CBUSH and Linear Gaps. The nodes are coincident. Do the CBUSH and the Linear GAP use the same 2 conincident nodes or does the Linear Gap require a intrmediate node? Can this be done?
I am trying to model lateral float into a joint using RBE2-to CBUSH and Linear Gaps. The nodes are coincident. Do the CBUSH and the Linear GAP use the same 2 conincident nodes or does the Linear Gap require a intrmediate node? Can this be done?
The question at this point is whether you model is stable with the gap(s) open or not. If it is not stable with it/them open, a small spring (or several small springs) may be required for statbility. If it is stable with the gap(s) open, then it shouldn't require any special modeling.
The question at this point is whether you model is stable with the gap(s) open or not. If it is not stable with it/them open, a small spring (or several small springs) may be required for statbility. If it is stable with the gap(s) open, then it shouldn't require any special modeling.
