How can I get the the output for the DISP command in the Basic system? I´m using SOL101, and the command OPPHIB does not work for this solution.

0 Don.Graff over 6 years ago

How do you want these displacements (printed, punched, op4)? If looking to get the displacement output from PARAM,POST to be in BASIC, then add:

PARAM,OUGCORD,BASIC
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 lsilva over 6 years ago

Thanks Don. But as you mentioned , I was looking for a ".f06" printed version (punched or op4 will also do).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Don.Graff over 6 years ago

I already have an ALTER that will punch out the SOL101 displacements in basic CS... I'll attach the alter and a sample input file so you can test it out. If you do not want the original CS displacements punched out, as well, then remove the PUNCH flag from the DISP case control command.

Attached Files (1)

DMAP_basic_out.alt.zip
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Don.Graff over 6 years ago

here is a sample input file...

Attached Files (1)

a101.dat
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Don.Graff over 6 years ago

just tried adding the following line to the alter, right after the existing punch command, and it prints to the f06:

OFP BOUGXX,,,,,,,,,,,,///1 $ call OFP to print the table

The printout in the f06 for CS0 will be first, followed by any print request you might already have.

Please let me know if you have any issues, but be sure to do your own validation/testing!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 lsilva over 6 years ago

Thanks for the prompt answer. I´ll try it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel