This error is often the 'final' error, indicating the job didn't get to a solution point... but there are usually more errors with a more appropriate message pointing to the likely problem.
Can you send the full f06 file? Or look in it for further messages, both WARNING and FATAL?
Can't send the f06, but I do get the following when I run 2008
USER WARNING MESSAGE 2 (MCNTDAT)
USER WARNING MESSAGE BCBODY (Not found)
USER WARNING MESSAGE 2 (MCNTDAT)
USER WARNING MESSAGE 0 (0)
USER WARNING 2 (MNCTINI)
USER WARNING MESSAGE 0 (0)
When I run it with 2013, I get a fatal that bcbody 0 doesn't exist. In my contact table, I do have a couple cases where my slave has 0 and 1 in the line below, but no where do i have a master or slave labeled as 0. So i'm kind of stumped.
This is going to require more debugging than can be done on this forum... how about opening a customer service request and get technical support directly?
