SYSTEM FATAL MESSAGE 3003 (GKAM)

Does anyone know this Message ?

ATTEMPT TO READ PAST THE END OF A LOGICAL RECORD IN DATA BLOCK DITS (FILE 105) IN SUBROUTINE PRETAB

Comming from a nastran run, with Nastran Version 2017.1.0-CL479603 + ACMS.

The request was calculating velocity for structural nodes in a couppled Fluid/Structure Analysis (SOL111). Response for fluid nodes was not requensted.

0 Hrishikesh Phadke over 6 years ago

Hi Thomas,

Please check if your TABDMP1/TABLED entries are in proper syntax. Also can you try running without ACMS /DMP/etc for identifying the problem area.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 thomas.roy over 6 years ago

Thank_'s a lot hrishikesh. You are right. I get lost of the continius line in the tabdmp1 entry.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel