In General, how to validate the Dynamic Analysis results. (i.e.) We used to check Reaction forces for linear static Analysis. If AUTOSPC is used in Analysis, how to validate the results in Dynamic analysis.

In General, how to validate the Dynamic Analysis results. (i.e.) We used to check Reaction forces for linear static Analysis.
If AUTOSPC is used in Analysis, how to validate the results in Dynamic analysis.

0 rohit.belsare over 5 years ago

There are many ways to verify the dynamic analysis result, below are some you can refer.

1. You can check grid response on which you have applied the load

2. Check the peak in the plot and corresponding frequency, co-relate this with your engine value analysis for any nearby of the peak.

3. for further detail description on procedure to verify the dynamic result you can please refer chapter no. 15 in Dynamic user guide

Thanks,
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ntv2 over 5 years ago

Thanks for your reply.

Kindly let me know, where I can download the DYNAMICS USER GUIDE ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 rohit.belsare over 5 years ago

check this link,

https://simcompanion.mscsoftware.com/infocenter/index?page=content&id=DOC11514
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ntv2 over 5 years ago

Thanks a lot !
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Don.Graff over 5 years ago

There is also a Webinar on Model Checks for Dynamic Analyses:

https://simcompanion.mscsoftware.com/infocenter/index?page=content&id=WM155
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel