I want to connect tet meshed bodies together using glue elements for modal and static analysis. Can the free face of the elements in each region be use for the connection or only entire elements?
I want to connect tet meshed bodies together using glue elements for modal and static analysis. Can the free face of the elements in each region be use for the connection or only entire elements?
There is a LOT of material on doing contact... sometimes it is simple, sometimes it is difficult... always model dependent.
I'll point you to a bunch of material, and you can take a look. I suggest opening Technical Support cases for specific questions rather than using the Forum.
These are all webinars (the first one is on contact body pairs, using the newer approach):
There is a LOT of material on doing contact... sometimes it is simple, sometimes it is difficult... always model dependent.
I'll point you to a bunch of material, and you can take a look. I suggest opening Technical Support cases for specific questions rather than using the Forum.
These are all webinars (the first one is on contact body pairs, using the newer approach):
