In a sol 112 run I get the message although the mentioned grid point is defined: *** USER FATAL MESSAGE 2008 (GP3) LOAD SET 1049 REFERENCES UNDEFINED GRID POINT 2 The grid point also exists in the op2-file of the broken simulation.

In a sol 112 run I get the message although the mentioned grid point is defined:
*** USER FATAL MESSAGE 2008 (GP3)
LOAD SET 1049 REFERENCES UNDEFINED GRID POINT 2
The grid point also exists in the op2-file of the broken simulation.

0 Vivek Bhardwaj over 2 years ago

Can you please share the input file? if not complete, the portion of loading and grids?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 i.spiropoulos over 2 years ago

Unfortunately, I cannot share share any of the files. I found out that when I take out the superelements that exist in the model this error doesn’t occur anymore.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Vivek Bhardwaj over 2 years ago

If superelement used here is external superelement and the loading grid is interior to that. In this condition try to put the loading grids in ASET. With this it will be available and cane be used in assembly job.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel