I have to perform a thermoelastic analysis of a optic, where I have the start temperature of the optic and the time history of the temperature on one face.

In the past, I have run static thermal analysis using discrete temperatures to generate temperatures at all structural nodes for further stress analysis.

I am looking for examples I can study in the setup of a run to compute nodal temperatures from a known boundary condition in order to get started.

Thank you,

Derek

Parents

0 derek.lewis over 3 years ago

The time varying temperatures would be generated and used in the same model for calculating stresses, so there is no separate mapping step. Also, I will use FEMAP as the pre/post processor for this analysis.

Derek
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 derek.lewis over 3 years ago

The time varying temperatures would be generated and used in the same model for calculating stresses, so there is no separate mapping step. Also, I will use FEMAP as the pre/post processor for this analysis.

Derek
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data