I have a model with glued contact..I can get ouput for stress, CBUSH/ELFORCE, displacements,etc.,et .but I can NOT get contact status to show up in PATRAN, either for H5 or .OP2..what am i doing wrong?
I have a model with glued contact..I can get ouput for stress, CBUSH/ELFORCE, displacements,etc.,et .but I can NOT get contact status to show up in PATRAN, either for H5 or .OP2..what am i doing wrong?
I'm going to reduce the size of the model to capture the areas that seem to be problematic (proprietary/security issues here), and send it over//probably Monday. Since
The model is doing what I expect.. Since I'm not up to speed with all the PATRAN_related post-processing options , I'm wondering if the MDLPRM card is not setup right..
But.......thanks for your help Sanjay. When I call the Hex support phone number, I never get a person..always have to leave a message, and a short one at that..it
Discconnected me twice this week when I was leaving a message related to these issues
I'm going to reduce the size of the model to capture the areas that seem to be problematic (proprietary/security issues here), and send it over//probably Monday. Since
The model is doing what I expect.. Since I'm not up to speed with all the PATRAN_related post-processing options , I'm wondering if the MDLPRM card is not setup right..
But.......thanks for your help Sanjay. When I call the Hex support phone number, I never get a person..always have to leave a message, and a short one at that..it
Discconnected me twice this week when I was leaving a message related to these issues
