Associate geometry /hard geometry

When I associate a curve with a surface, I would expect that for the meshing, the mesh would consider the complete line for the meshconnection. But it seems only the outer points are considered for the mesh, see attached picture.

I want to have a connection between 2 surfaces and this should be the way to do this?

Attached Files (1)

Parents

0 ron.kunz over 6 years ago

a.Isomesh is not possible because it is not biparametric (you only see part of the surface)

b. The line is created in Patran by project line on surface, so the hard surface should lie on the surface?

I projected a line, created a surface in between and afterwards combine two surfaces. But not the intersecting surfaces. But with Paver this is meshed like I want to have it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 ron.kunz over 6 years ago

a.Isomesh is not possible because it is not biparametric (you only see part of the surface)

b. The line is created in Patran by project line on surface, so the hard surface should lie on the surface?

I projected a line, created a surface in between and afterwards combine two surfaces. But not the intersecting surfaces. But with Paver this is meshed like I want to have it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data