Associate geometry /hard geometry

When I associate a curve with a surface, I would expect that for the meshing, the mesh would consider the complete line for the meshconnection. But it seems only the outer points are considered for the mesh, see attached picture.

I want to have a connection between 2 surfaces and this should be the way to do this?

Attached Files (1)

Parents

0 ron.kunz over 6 years ago

Thanks all.

Darrel regarding your attachement: the first line quotes:

"Surface mesher used for Tetmesh"

I have a solid which I will mesh with a Tethmesh (Tet10). Also I have a hard geometry curve on this solid. With Tetmesh I also get the same issue with Hybrid on a surface. Only some points are selected for the mesh. How can I change this? Preferred for this bar is of course a hexmesh.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 ron.kunz over 6 years ago

Thanks all.

Darrel regarding your attachement: the first line quotes:

"Surface mesher used for Tetmesh"

I have a solid which I will mesh with a Tethmesh (Tet10). Also I have a hard geometry curve on this solid. With Tetmesh I also get the same issue with Hybrid on a surface. Only some points are selected for the mesh. How can I change this? Preferred for this bar is of course a hexmesh.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data