Automating a result

Hello,

I am trying to plot graph and write our the curve for few nodes in the model. I need to these steps multiple times for various load cases. I was trying to create a session file and play it so that it automates and somehow the session file halts/crashes when processing these results.

PS. I am doing this for transient solution so there are quit a few time steps.

Parents

0 shaheer.iqbal over 5 years ago

The above command was not working for me. I tried the same method but this time use create report tab. Since create report tab does not displays the data (graph) it easily writes out the *.rpt file with a session recording.

One questions in terms of report output, I am using a transient run and interested in displacement plot. in the report format I have a lot of information of each time step. Is there a way to just record displacement out rather than information about time steps. Each report I need to remove these time steps data entities
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 shaheer.iqbal over 5 years ago

The above command was not working for me. I tried the same method but this time use create report tab. Since create report tab does not displays the data (graph) it easily writes out the *.rpt file with a session recording.

One questions in terms of report output, I am using a transient run and interested in displacement plot. in the report format I have a lot of information of each time step. Is there a way to just record displacement out rather than information about time steps. Each report I need to remove these time steps data entities
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data