Thermal simulation with Sinda in Patran

Hello,

I'm preforming some simulations in Sinda, and when I try to initiate the simulation this stay sucked and don't start. With tutorial works fine, but when I try to do in a simple electronic box doesn't work.

I only have 15 tokens and Patran uses 13. Is related with that? Like Nastran I can generate the SIN file and preform after?

Parents

0 Arthur Hickson over 5 years ago

Hi Carlos,

Sorry, initially I didn't look too closely at the token count issue I just thought it was an issue with running the analysis and Patran together. I've now looked at the MSCOne token table and the Sinda Patran plugin requires 4 tokens, I mistakenly thought it would be just a couple of tokens but it isn't. Whilst you can shut Patran and run the sinda analysis outside once you have the files, the writing of the "jobname".ini file is done from within Patran by the Sinda Plugin and loading this plugin must be exceeding your token count.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Arthur Hickson over 5 years ago

Hi Carlos,

Sorry, initially I didn't look too closely at the token count issue I just thought it was an issue with running the analysis and Patran together. I've now looked at the MSCOne token table and the Sinda Patran plugin requires 4 tokens, I mistakenly thought it would be just a couple of tokens but it isn't. Whilst you can shut Patran and run the sinda analysis outside once you have the files, the writing of the "jobname".ini file is done from within Patran by the Sinda Plugin and loading this plugin must be exceeding your token count.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data