Hello,
I performed the contact analysis using SOL400. I would like to check the Interlaminar stresses (Sigma1, Sigma2 and Sigma(3 or 12) of the CFRP Structure using Patran.
In the Post processing Results section of Patran, to check the Interlaminar stress I noticed options as Interlaminar Stress, Normal and Interlaminar Stress, Shear. Is they are same as Interlaminar stresses (Sigma1, Sigma2 and Sigma(3 or 12))?
I never performed SOL 400 using CFRP Structure.
Thanks
Prasad
