Your Products have been synced, click here to refresh
As others have stated you can do a readpoint, make sure you place a operator comment before the read point something like " place the tip inside the ID as close to the center as you can, about .100 below the surface "
Then create a circle auto or measured and that's it. Not the best method but it does exactly as you want.
Operator Comment
Read point
Alignment with XYZ zero on the read point
Measured or auto Circle.
Dimension
You will still need an alignment bit its an easy one. Only XYZ orgin. Once you have creayed that program, just do save as and create many more programs with different sizes and hits.
Or if you want to do it right measure it as a cylinder and level to it.
Ps. To get the readpoint, just simply start typing readp then clcik tab and it should create a readpoint.
As others have stated you can do a readpoint, make sure you place a operator comment before the read point something like " place the tip inside the ID as close to the center as you can, about .100 below the surface "
Then create a circle auto or measured and that's it. Not the best method but it does exactly as you want.
Operator Comment
Read point
Alignment with XYZ zero on the read point
Measured or auto Circle.
Dimension
You will still need an alignment bit its an easy one. Only XYZ orgin. Once you have creayed that program, just do save as and create many more programs with different sizes and hits.
Or if you want to do it right measure it as a cylinder and level to it.
Ps. To get the readpoint, just simply start typing readp then clcik tab and it should create a readpoint.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |