If a Blueprint calls for ASME Y14.5 wouldn't this be the standard rules apply. How would I know if and when to apply ISO? I have yet to see anything on a blueprint stating this. The reason I bring this up is for the good old Profile callout. Before I make an argument, I want to cover all my resources. Customer already claims in an email that PC-DMIS is not capable of doing this. I and everyone on here already that's horse_S_H_I_T. But its Friday and I'm ready to P_I_S_S someone off
The customer claims PC-DMIS cannot. I already know that in XACTMEASURE it can. My question is that on the blueprint should it say CHECK according to ISO, now according to
AndersI this is not ISO?
The customer claims PC-DMIS cannot. I already know that in XACTMEASURE it can. My question is that on the blueprint should it say CHECK according to ISO, now according to
AndersI this is not ISO?
Kirby, a print cannot be both ASME and ISO. If it says ASME, then it's ASME. If it say ISO, then it's ISO. ISO and ASME are two wholly different standards. They are not applied case by case. You can't apply ISO to the surface profile when the print says interpret per ASME.
And if it doesn't say either way, then flip a coin.
VinniUSMC, Theres the answer I was looking for. Hey do you have an actual print that shows Interpret the drawing according to ISO? Maybe send me a snap shot like the one above. I do not have a print that states this
We have a customer that has a print that specifically says to measure to ASME Y14.5M-2009, but wants the profile to be in ISO (2x the maximum deviation). How about them apples?
KIRBSTER269, Ha! I was told by this customer that it is "industry standard" to do 2x the max deviation, so we need to measure it that way. Oh well...the customer is always right...in their eyes.