If a Blueprint calls for ASME Y14.5 wouldn't this be the standard rules apply. How would I know if and when to apply ISO? I have yet to see anything on a blueprint stating this. The reason I bring this up is for the good old Profile callout. Before I make an argument, I want to cover all my resources. Customer already claims in an email that PC-DMIS is not capable of doing this. I and everyone on here already that's horse_S_H_I_T. But its Friday and I'm ready to P_I_S_S someone off
I just browsed thru the whole thread, and I still don't quiet understand is there an actual definition of how the profile is measured based on the y14.5-2009 or 1994???
is it double the worst reading or just the upper and lower combined?
The actual profile reading is the Max and Min. Whatever the tolerance zone is. The only question is "do the max and min fall within the tolerance zone?"
2x max could only apply to bilateral equally distributed profiles (hypothetically, if it were the ASME way).
The actual profile reading is the Max and Min. Whatever the tolerance zone is. The only question is "do the max and min fall within the tolerance zone?"
2x max could only apply to bilateral equally distributed profiles (hypothetically, if it were the ASME way).
