I have a quick question, I am using Xactmeasure to do true position of a few holes and at the end of the report it also shows my datum out of tolerance, what does this mean?
sorry I'm still very new to all this and have mostly been using legacy dimension
I use Xact almost exclusively. The columns in that bottom row represent different information than what's represented in the rest of the table.
Josh Carpenter could probably elaborate on this. While in my experience the other numbers are usually accurate, the instance of datums showing in red is an ongoing issue that Hexagon apparently doesn't care to address. It's kind of annoying when you have to present a report to your superiors that shows red numbers that you can't explain.
I use Xact almost exclusively. The columns in that bottom row represent different information than what's represented in the rest of the table.
Josh Carpenter could probably elaborate on this. While in my experience the other numbers are usually accurate, the instance of datums showing in red is an ongoing issue that Hexagon apparently doesn't care to address. It's kind of annoying when you have to present a report to your superiors that shows red numbers that you can't explain.
