I'm using mm3, and im trying to find the angle of hole to hole. The holes are a tapped hole ( m4-.07) so there small.
What would be the best way to do that?
Document - Drawing Angle - Created Jul 13, 2017.pdf
Its hard to tell with just a snippet of the print but based on that I would create a line from each circle to the OD or ID (which ever is the Datum) and check the angle of the line.
Its hard to tell with just a snippet of the print but based on that I would create a line from each circle to the OD or ID (which ever is the Datum) and check the angle of the line.